Great Tips on Clutch Replacement
By Charles on Mar 20, 2011 with Comments 0
Here are some important tips for clutch replacement. You will develop certain strategies that depend on how well understand the vehicle and any previous experience that you have of dealing with the clutch. These tips are meant to be pointers that help you to become more effective in the work that you are doing. Of course you may have other ideas that are different from this setting. Look at the car manual to see whether you are indeed following the instructions that have been given.
A supported transmission system
It is certain that you will need a jack in order to support the vehicle. This will give you the space to work without worrying about the vehicle falling down. You should use a good quality jack that can support the weight of the vehicle. You need to remove the transmission cross member and then tie it up with bolts. The system must be titled downwards in order to help you with all the processes that you are undertaking. The radiator fan should be watched so that you do not make a mistake as you tilt the engine.
Blades and car transmission
When undertaking clutch replacement, you need to ensure that the blades are put in an X shape. That setting will offer you a lot more clearance to work. The radiator hoses may also have to be checked to ensure that they are not interfering in the process that you are undertaking. It must be noted that the L20B has been found to stretch less than the upper radiator hose. Therefore you need to do your estimations carefully to ensure that the vehicle is responding appropriately to the repairs that you are undertaking.
Removing the carburetor linkage
This is an essential aspect of clutch replacement. You have to remove it in such a way as not to tamper with the other parts. The connection to the firewall has to be handled with great care or else it could all backfire. You need to first remove all the bolts and then work towards making the system more efficient in the way that it operates. As you secure the different parts then it is possible that you can remove the clutch slave cylinder as well. Once the transmission has been unbolted then you can roll the floor jack back.
Oiling all the relevant parts
The process of clutch replacement might require that you oil certain parts. Make sure that you use a good lubricant and that you dispose of the old clutch discs appropriately. Scientific research has shown that these discs contain asbestos fibers which are hazardous to human health. The last thing that you need to allow is for younger children to get in contact with these materials. It will make matters worse for you in the long run. The flywheel dowel should be left on the pegs as you work. You need to secure the pegs quite accurately in order to ensure that the installation is complete according to minimum standards.
Pressure plates
Make sure that the pressure plates are nicely bolted as you work. You need to check out the center in particular to ensure that it meets your requirements as you work. These are the sorts of considerations that can make a difference to the way that you deal with the various elements of your clutch management program. The process of clutch replacement is all about following the right procedures at the right time. The rest will soon fall into place depending on your vehicle type.
Filed Under: Car Tuning • Guides/DIY